Skip to the tool
Speaker Cleaner

Water Removal Sound

Phone just got wet? Follow the timeline below, hold the speaker facing down, set full volume and press Start. Judge the result between runs.

165Hz

Ready

60seconds left

165 Hz pulse that pushes droplets out of the grille. 60 seconds.

Set volume to maximum, turn off silent mode, and hold the phone with the speaker facing down.

Disconnect Bluetooth headphones first, otherwise the sound plays there instead of the phone speaker.

Check the result

Play each side. A clean speaker sounds clear and equally loud on both channels.

Minute by minute after a phone gets wet

The first ten minutes matter because the water is still loose. It has not dried into the mesh or pulled dust in with it. Work through these steps in order and do not skip the dull ones.

  1. Minute 0 to 1: Get the phone out of the water. Unplug any cable, take off the case and wipe the whole phone with a towel or your shirt. Do not plug anything in.
  2. Minute 1 to 2: Check that the phone behaves normally. If the screen flickers, the phone gets hot or it restarts on its own, switch it off and leave it off. Sound cannot help a phone with water inside. A liquid warning on its own is about the charging port, so just keep the cable out.
  3. Minute 2 to 3: Get ready. Disconnect Bluetooth, turn silent mode off and set the media volume to maximum.
  4. Minute 3 to 4: Hold the phone with the speaker grille facing the floor. Choose Water mode on this page, press Start and let all 60 seconds play.
  5. Minute 4 to 6: Dab the grille with a dry cloth. Do not press into the mesh. Then play a song you know, or use the speaker test on this page, to hear whether the sound is clearer.
  6. Minute 6 to 10: If the sound is still dull, run Water mode once more and dab again. Then stop and judge the result using the next section.
  7. The next hours: Leave the phone in open air, grille down, away from a heater and direct sun. Apple advises waiting at least 30 minutes before charging a wet iPhone with a cable. On any phone, wait longer if the port still looks wet.

How many runs, and how to judge between them

One or two runs is normal. Judge every run the same way: play the same song at the same volume, or press Both in the speaker test.

Ask three questions. Is the voice clearer? Is it louder? Did any water come out onto the cloth? If one answer is yes, run it once more. If nothing changed after the second run, wait ten minutes and try again.

If three or four runs change nothing, the problem is probably not water in the grille. Stop playing the sound. The water may be deeper inside, or the speaker may be damaged. A repair shop or the phone maker is the right call.

What to skip, even though people suggest it

  • Rice. Apple advises against it, and rice is no faster than open air.
  • A hair dryer or any other external heat. Heat can harm the seals and the battery.
  • Hard shaking or flicking. It can push droplets further in through the grille and the charging port.
  • Charging early. Power plus wet contacts is how corrosion starts.
  • Compressed air, swabs, pins or paper in the grille or port. They push water further in or tear the mesh.

Pool, sink, shower or rain: how the source changes the plan

  • Pool water: chlorine and minerals leave residue as they dry. After the first run, dab the grille with a cloth slightly dampened with fresh water, dry it, then run again.
  • Sink water with soap: soap can leave a film on the mesh as it dries. Wipe the outside with a cloth dampened with fresh water, dry it, then run Water mode.
  • Shower steam: this is usually fine droplets fogging the mesh rather than a splash. One run and some time in dry air is often enough.
  • Rain: usually a small amount of fresh water. Run it once, dab the grille and leave the phone to air dry.

Still muffled the next morning?

Give the phone a night in open air, then test it again. If it still sounds underwater, run Water mode once more. A liquid detected warning is about the charging port, and sound does not dry the port, so leave that to time.

If the speaker is still dull or crackles after a few runs spread over a day, book a repair.

Will water in a phone speaker dry?Water eject sound

Questions people ask

What should I do in the very first minute after my phone falls in water?

Take it out, unplug anything attached, remove the case and wipe the outside. Do not plug in a charger. The sound comes a few minutes later.

Should I switch the phone off before running the sound?

Only if it is behaving strangely: a flickering screen, heat or random restarts. A phone that works normally can play the sound. A phone with water inside should stay off.

How long should I wait between two runs?

If the first run changed nothing, wait about ten minutes. Water keeps moving as it dries.

Is a hair dryer on the cool setting safe?

Apple advises against external heat, and moving air from a dryer can still push droplets into the phone. Open air and patience are safer.

Is it too late if the phone has been wet for an hour?

No. Run the sound anyway. Water that has sat longer may have left residue, so wipe the grille with a slightly damp cloth, dry it and run again.

More cleaning tools