Skip to the tool
Speaker Cleaner

Sound Cleaner

This sound cleaner uses your speaker's own vibration to shake loose dust out of the grille. Face the grille down, raise the volume and press Start in Dust mode.

200Hz

Ready

60seconds left

A rising sweep from 200 to 1200 Hz that shakes loose dry dust and lint. 60 seconds.

Set volume to maximum, turn off silent mode, and hold the phone with the speaker facing down.

Disconnect Bluetooth headphones first, otherwise the sound plays there instead of the phone speaker.

Check the result

Play each side. A clean speaker sounds clear and equally loud on both channels.

What a sound cleaner does

A sound cleaner is a tone that makes a speaker clean itself. The speaker cone moves back and forth to make sound. When it plays a strong, low or sweeping tone, that movement shakes the air in front of it and the mesh over it. Water droplets and loose dust get pushed toward the outside.

On this site the tones are generated live in your browser. Nothing is downloaded and the microphone is never used.

Sound as a cleaning method

Using vibration to loosen dirt is an old idea. Ultrasonic cleaners for jewellery or glasses work on the same basic principle: vibration shakes dirt off a surface. They are not the same thing as this tool, though. They use sound far above human hearing, usually in a liquid bath, and clean the object placed in it.

The tones here are audible, play in the air and act on your speaker grille only. Holding jewellery, glasses or other objects near your phone will not clean them.

What it can remove and what it cannot

Sound moves things that are loose. It does not dissolve or scrape anything.

  • It can help with water droplets sitting in the mesh.
  • It can help with loose dust and lint.
  • It cannot remove grime glued down by skin oil.
  • It cannot remove earwax, which sticks and needs a soft dry brush.
  • It cannot remove dried sugary residue from a spilled drink.
  • It cannot fix corrosion, a torn cone or a blown speaker. Those need a repair shop or the manufacturer.

Does a speaker cleaner work?

Not noise-removal software

A different kind of tool also goes by a similar name. Noise-removal software removes background noise, hiss or hum from recordings and calls. This is not that.

This sound cleaner works on the physical speaker grille. It does nothing to a recording, cannot clean up a noisy video and does not improve call quality. It also does not listen to anything, because it never uses the microphone.

Using it as a dust sound cleaner

  1. Wipe the phone with a dry cloth and remove the case.
  2. Turn the volume to maximum, switch off silent mode and disconnect Bluetooth.
  3. Hold the phone with the speaker grille facing down, so loosened dust can fall out.
  4. Press Start in Dust mode. The sweep glides up and down between 200 and 1200 Hz for 60 seconds.
  5. Brush the grille lightly with a soft dry toothbrush, then play a song or voice note.
  6. Run it once more if the sound is still dull. Stop after a few runs and look for another cause.

More on the dust cleaner sound

Questions people ask

Is a sound cleaner the same as an ultrasonic cleaner?

No. Both use vibration, but ultrasonic cleaners use sound above human hearing in a liquid bath to clean objects. The tones on this page are audible and only act on your speaker grille.

Can a sound cleaner remove background noise from my videos?

No. It plays tones through your speaker and does nothing to recordings. To reduce noise in a video you need audio editing software, which is a different kind of tool.

Will a sound cleaner remove earwax from my earpiece?

Not reliably. Earwax is sticky and does not shake loose. Brush the mesh gently with a soft dry toothbrush, and use the sound afterward for any loose bits.

Why does Dust mode sound so buzzy?

It uses a sawtooth wave, which has more overtones than a plain sine tone. The sweep also moves up and down in pitch, which shakes dust at several frequencies in one run.

Does a sound cleaner help a phone that never got wet?

Yes, if the problem is loose dust or lint. That is what Dust mode is for. If the speaker got quieter slowly with no water involved, run Dust mode and brush the grille lightly.

More cleaning tools