Skip to the tool
Speaker Cleaner

Clean My Speaker

In a hurry? Tick the five checks, press Start in Water mode, then wipe the grille. The whole thing takes about a minute and a half.

165Hz

Ready

60seconds left

165 Hz pulse that pushes droplets out of the grille. 60 seconds.

Set volume to maximum, turn off silent mode, and hold the phone with the speaker facing down.

Disconnect Bluetooth headphones first, otherwise the sound plays there instead of the phone speaker.

Check the result

Play each side. A clean speaker sounds clear and equally loud on both channels.

Five checks before you press Start

Each check removes a common reason the cleaner seems to do nothing. Maximum volume gives the cone room to move. Silent mode can mute media on some phones. Bluetooth sends the tone to your earbuds instead of the phone. A case can cover the grille. Facing down lets water and dust fall out instead of settling back in.

  • Volume at maximum.
  • Silent mode off.
  • Bluetooth off.
  • Case off.
  • Speaker grille facing down.

The 60-second routine

Prep takes about 10 seconds. The run takes 60. The wipe takes a few more. Do not shake the phone or tap it on a table while the sound plays. Just hold it steady with the grille down and let the tone do the work.

  1. Do the five checks above.
  2. Hold the phone with the speaker grille facing down.
  3. Press Start in Water mode.
  4. Keep the phone still until the countdown reaches zero.
  5. Wipe the grille with a dry cloth.
  6. Play a voice note and listen.

How to tell it worked

Play a voice note or a song you know well and compare it with how it sounded before. For a quick extra check, open the speaker test and press Left, then Right. On a phone with one speaker both come from the same place, and that is normal.

Any of these signs means the run worked:

  • Voices sound clearer and less boxed in.
  • Bass and low notes return.
  • Crackle or a fuzzy edge is gone or smaller.
  • The Left and Right test plays a steady 440 Hz tone with no rattle.

Run the speaker test

If it did not work: one next step

Pick one path. If no water was involved, switch to Dust mode and run it once. The buzzier sweep loosens lint and dust that a single low tone leaves behind.

If water was involved and the sound is still dull, try Deep clean, which runs for 2 minutes. If nothing changes after a few runs, the cause is probably not water in the grille. A soft dry toothbrush on the mesh is the next move, and after that a repair shop. Each of these is a one-step move, so you never need to start the routine from scratch.

Questions people ask

What is the quickest way to clean my speaker?

Remove the case, set the volume to maximum, point the grille down, run one Water mode session of 60 seconds, then wipe the grille. That is the whole fast routine.

Is one run enough for a speaker that is only slightly dull?

Often it is. Slight dullness usually comes from a little moisture or dust on the mesh, and one run can move it. Listen first, and run again only if the sound has not changed.

Can I skip the wipe at the end?

You can, but it helps. Droplets that reach the grille stay on the mesh until you dab them away. A dry cloth takes a few seconds and stops them sliding back in. Wiping also helps you spot any liquid that came out, which tells you the run did something.

What if I cannot take the case off right now?

Run it anyway if you must, but a thick case can cover the grille and block the sound. Take it off when you can and run the routine again. If the case is a thin one with open cut-outs, it is usually fine.

How soon can I tell whether it worked?

Straight away. Play a voice note as soon as the wipe is done. Water can keep draining for a few minutes, so check once more after five minutes.

More cleaning tools